Home › Failure Case Library › No Signal for Standard Curve with Normal Zero Standard
ELISA (Competitive) critical

No Signal for Standard Curve with Normal Zero Standard

Symptom
All standard concentrations show no signal (high OD in competitive format similar to zero standard), while the zero standard (no competitor) shows normal maximum binding signal.
Common Causes
  1. 1 Standard curve pipetting errors resulting in no analyte addition
  2. 2 Incorrect serial dilution procedure producing uniform zero concentration
  3. 3 Standard concentration far exceeds assay dynamic range causing complete inhibition at all points
  4. 4 Standard stock solution degraded or improperly reconstituted
Solutions
  1. 1 Verify the standard curve was pipetted and diluted properly with documented procedure
  2. 2 Check calculation of dilution factors and physically verify volumes
  3. 3 Decrease the starting standard concentration to fall within assay dynamic range
  4. 4 Prepare fresh standard from new stock and verify reconstitution protocol
Related Video (2)
Bilibili (China-Accessible Mirrors) ★ 72
How to Run an R&D Systems Quantikine ELISA
"Full Quantikine ELISA workflow with hands-on benchwork and troubleshooting guidance, useful for spotting standard-curve pipetting errors and proper standard preparation technique."
Bilibili (China-Accessible Mirrors) ★ 70
R&D Systems Quantikine ELISA Operation Guide
"Official step-by-step Quantikine protocol from sample preparation through detection clearly demonstrates standard/sample addition steps where the described pipetting failure would occur."
Source: abcam.com ↗
← Back to all cases